Removing toxic ammonia and solids is vital for fish health and water reuse in intensive recirculating aquaculture systems (RAS). In traditional RAS, ammonia is nitrified to nitrate and removed, while solids are discarded. We recently developed a microbial-assimilation-based RAS (B-RAS), in which ammonia-rich effluent and solids are diverted to a biofloc reactor. In this reactor, heterotrophic bacteria use fish sludge and external carbon to assimilate ammonia into microbial biomass. Clarified water is returned to the tank, and settled biofloc is dried into a protein-rich meal for reuse as feed (Fig. 1). This study aimed to identify operating conditions that maximize ammonia assimilation and biofloc production. A B- RAS was operated under three redox regimes controlled by oxidation-reduction potential: anaerobic (< -300 mV), microaerophilic (-100 to +100 mV), and aerobic (150 to 400 mV). Across three campaigns, the C:N ratio was maintained at 15:1. Total ammonia nitrogen (TAN), particulate organic carbon, and particulate organic nitrogen were used to quantify assimilation via mass balance.
Microaerophilic operation achieved the highest nitrogen assimilation, capturing 43.6% of applied N, compared with 32.6% under aerobic and 20.7% under anaerobic conditions. TAN remained low in the microaerophilic and aerobic regimes (below 1.5 mg/L) but increased under anaerobic operation (17 mg/L). Contrary to our initial hypothesis that aerobic conditions would maximize biomass yield, the microaerophilic regime produced the highest yield, likely because less nitrogen was lost through nitrification in the reactor, followed by denitrification in the settler tank that operated mostly under an aerobic conditions. Biofloc protein content was highest under microaerophilic conditions (60.2%) compared with aerobic (49.5%) and anaerobic (31.3%) conditions . These results define a practical redox operating window for coupling ammonia control with waste-to-biomass recovery in B-RAS and support controlled microaerophilic operation as an actionable setpoint.